AVR7300(120v)-OM 6/14/04 9:15 AM Page 7
FRONT-PANEL CONTROLS
13579111315
2468101214
NOTE: To make it easier to follow the instructions that refer to this illustration, a larger copy may be downloaded from the Product Support section for this product at
www.harmankardon.com.
The following controls and jacks are located behind the front-panel door. To open the door, place the edge of a finger on the left or right bottom edge of the panel and gently
swing the door down toward you.
1Main Power Switch6Digital Input Selector11Optical Digital Output
2Headphone Jack7Delay Adjust Selector12Coaxial 4 Digital Input
3Tone Mode Button8?/?Buttons13Coaxial Digital Output
4Speaker Selector Button9Set/Video Button14Video 5 Audio/Video Jacks
5Channel Adjust Selector10Optical 4 Digital Input15Input/Output Indicator
standard stereo signal. You may also use one of the
1Main Power Switch: Press this switch to4Speaker Selector Button: Press this button
Dolby Headphone modes for an enhanced listening
apply power to the AVR 7300. When the switch isto begin the process of configuring the AVR 7300 for
experience. For more information on headphone lis-
pressed in, the unit is placed in a Standby mode, asthe type of speakers it is being used with. For com-
tening, see page 35.
indicated by the lighting around the Standby/Onplete information on configuring the speaker settings,
Button 1 turning amber. The switch MUST be3Tone Mode Button: This button controls thesee page 26.
pressed in to operate the unit. To turn the unit off andtone mode settings, enabling adjustment of the bass
5
Channel Adjust Selector: Press the button to
prevent the use of the remote control, this switchand treble boost/cut. You may also use it to take the
begin the process of adjusting the channel level out-
should be pressed until it pops out from the fronttone controls out of the signal path completely for
puts using the source currently playing through your
panel so that the word OOFF� may be read at the topOflat� response. The first press of the button displays a
AVR. For complete information on adjusting the chan-
of the switch.TONE MODE message in the Lower Display
nel output level, see page 40.
Line $ and in the on-screen display. To take the
NOTE: This switch is normally left in the OON� position.
6
controls out of the signal path, press either of theDigital Input Selector: Press this button to
2Headphone Jack:This jack may be used to?/? Buttons8 until the display reads TONEbegin the process of selecting a digital source for
listen to the AVR 7300Os output through a pair ofOUT. To change the bass or treble settings, pressuse with the currently selected input. Once the button
headphones. Be certain that the headphones have athe button again until the desired option appears in thehas been pressed, use the ?/? Buttons8
standard 1/4" stereo phone plug, or that you use anLower Display Line $ and in the on-screen displayto choose the desired input and then press the
adapter, as needed, to convert the plug on your head-and then press either of the ?/? Buttons 8 toSet/Video Button9 to enter the setting into the
phones to the 1/4" jack used on the AVR. When theenter the desired boost or cut setting. See page 35unitOs memory. See page 35 for more information on
headphone jack is in use, the main room speakers willfor more information on the tone controls.digital audio.
automatically be turned off and the unit will output a
FRONT-PANEL CONTROLS 7 |
ACEC
